7
6
Tools Required:
Flat head screwdriver, Philips screwdriver
NOTE:
IF THE ISD MOUNTING PLATES ARE FACTORY INSTALLED, SKIP STEPS 2 TO 5.
2. With a flat head screwdriver, remove the two (2) screw caps located on the top left hand side of
the unit (figure 1).
3. Take the Left ISD Mounting Plate and place it as shown in figure 2. Line up plate holes with unit
top and fasten using two (2) #10-32 X 3/4" Screws provided.
4. On the top right hand side of the unit, loosen screws from the door top bracket about 1/4" out.
Do not remove screws completely
. Using a flat head screw driver lift the door top bracket about
1/8" from the door top surface (figure 3).
5. Take the Right ISD Mounting Plate and line up slots with the screws. Push the plate all the way to
right and tighten screws (figure 4).
6. Facing the front of the freezer, take the ISD assembly and insert it as shown in figure 5. Make sure
each bracket leg is inserted into each plate hook as shown in figure 6.
7. Insert plug from ISD assembly into the receptacle located on the rear bottom side of the unit
(figure 7).
8. Switch on power located at the rear of the ISD assembly to turn the LED's on.
1. Unpack ISD Assembly components. The following items are contained in the package:
ISD Assembly (Qty: 1)
A
D
ISD Mounting Plate - Left
(Qty: 1)
B
C
ISD Mounting Plate - Right
(Qty: 1)
#10-32 X 3/4" Screw, Philips
(Qty: 2)
FIG. 1
FIG. 2
B
FIG. 5
FIG. 6
REAR OF UNIT
REAR OF UNIT
A
B
C
BRACKET LEG
PLATE HOOK
D
FIG. 7
SWITCH
RECEPTACLE
FIG. 3
1/8"
DOOR TOP
BRACKET
LIFT BRACKET
HERE
FIG. 4
C
ILLUMINATED SIGN DISPLAY (OPTIONAL) INSTALLATION
ILLUMINATED SIGN DISPLAY INSTALLATION CONT’D.
