MINUS
40
MINUS40 (PTY) Ltd Head Office: 8 Manhattan Street | Airport Industria Ext 2 | Western Cape
Tel: +27 (0) 21 386 2290 | E-mail: service@minus40.co.za
MINUS40 Medical Warmer Instruction Manual
Medical Warmer
CHECKLIST
SYMPTOM
CHECK
※
Chamber does not heat
※
Is the power turned on?
※
Is the temperature set above chamber ambient temperature?
※
Is the circulation fan operational?
※
Is there voltage on the output terminal of the controller?
※
Is the door closed?
※
Contact Minus40 service representative
※
Unit will not power up
※
Check outlet for powerMake sure that is firmly attached to the door.
※
Check if warmer is plugged in
※
Check if the ON/OFF switch/circuit breaker is turned on
※
Contact Minus40 service representative
※
Audible alarm
※
The alarm is activated when actual temperature exceeds the set point
by 2°C.
※
High temperature
※
Low temperature
※
Contact Minus40 service representative
CLEANING INSTRUCTIONS
Interior and Exterior Cleaning
•
Please ensure that the unit has been disconnected from the
electricity supply.
•
The unit should be cleaned periodically with a non-abrasive
cleaner and soft cloth.
•
Do not use any detergents or abrasive
•
A damp cloth may be used provided that all surfaces are polished
dry afterwards.
GENERAL MAINTENANCE
DAILY
•
Ensure the air vent in the airflow insert panel is not obstructed.
•
Check that the number of bottles/bags, or blankets as applicable
does not exceed the maximum capacity per shelf or basket
•
Clean any spills with a clean, lint-fresh cloth
MONTHLY
•
Check that the door gasket for tears and holes.
•
Make sure that it is firmly attached to the door.
•
Check the seal when the door is closed.
•
Clean the outside of the warmer with stainless cleaner
•
Vacuum the fan - and vent opening
ANNUALLY
•
Complete a calibration (Service agents can be found online)
•
Complete a general service including an electrical test, check
safety devices, etc.
•
Check the set point compared to the actual temperature
displayed
•
Check the condition of the plug and cord and replace if damaged
•
Check the controller screen for excessive wear, make sure the
controller screen displays and operate properly.
•
Clean The shelves and interior of the warmer.
