10
2. Charge the batteries for ten (10) hours before use. The UPS will recharge the batteries
automatically whenever its power cord is plugged into a wall outlet. You may use the UPS
immediately without recharging, but the backup time may be less than the rating.
3. Connect the power cord of your computer equipment to the output receptacles of the UPS. Turn
on the computer equipment.
DO NOT PLUG LASER PRINTERS INTO THE UPS BECAUSE THEY DRAW TOO
MUCH POWER.
4. CP500, CP1K , CP2K/2
Turn on the UPS by depressing the front panel switch to the position " | ". The "LINE" "BYPASS"
and "LOAD LEVEL" LED's will light up. After a few seconds the "INVERTER" will light up, too.
About 25 seconds later, the "BYPASS" LED will go off. Now, the UPS is working properly.
5. CP3K/2
Turn on the UPS by depressing the panel switch to the position " | ". All LEDs on panel will light
up. Then, check load level LED one by one, and all load
level LEDs flash again. After a few
seconds the "INVERTER" indicator will light up. About 25 seconds later, the "BYPASS" LED will
go off. Now, the UPS is working properly. If the "LOAD LEVEL" shows it is over 100%, buzzer
beeps twice per second. It means that you have connected too many
devices to the UPS.
Unplug the least critical equipment, such as printer, etc.
