6
When replacing batteries, use the same number and the following type batteries:
Matsushita (or Panasonic) Electric Works. Type LCR12V6.5P, rated 12V.
Do not dispose of battery or batteries in a fire, the battery may explode.
Do not open or mutilate the battery or batteries, released electrolyte is harmful to the skin
and eyes. It may be toxic.
A battery can present a risk of electrical shock and high short circuit current. The
following precautions should be observed when working on batteries.
Remove watches, rings or other metal objects.
Use tools with insulated handles.
For safe and continuous operation of the UPS depend partially on the care taken by user. Please
observe the following precautions:
Do not disassemble the UPS.
Do not attempt to power the UPS from any receptacle except a 2-pole 3-wire grounding
receptacle.
Do not place the UPS near water or in environment of excessive humidity.
Do not allow liquid or any foreign object to get inside the UPS.
Do not block air vents in front of the UPS or air exhausts in the back.
Do not plug appliances, such as hair dryers, into the UPS receptacles.
Do not place the UPS under direct sunshine or close to heat-emitting source.
A certified detachable power supply cord is to be used with this equipment. For a related
current up to 10A, a type not lighter than HO5VV-F3G 0.75mm
2
shall be used. For
CP3K/2, rated current 16A, a type not lighter than HO5VV-F3G 1.5 mm
2
shall be used.
Caution
- Electric shock hazard. Battery circuit is not isolated from the input voltage.
There may be hazardous voltage between battery terminals and ground. Check that
there is no voltage before touching!
Caution
-- Electric shock hazard. Even after disconnection from the mains input
voltage, components inside the UPS are still connected to the battery and are at
hazardous potential. Disconnect the battery supply circuit before carrying out servicing or
maintenance work.
1.4 DISPLAYS AND SWITCH
MAIN switch: Turn on the UPS by depressing the front panel switch into the position " | " and
turn off the UPS by depressing switch to the position " ".
LINE LED: This light means that the incoming AC line is normal.
BYPASS LED: The light means that the UPS is providing power directly from the incoming
AC line through the bypass line.
