32
After Use
After Use
1. When finished scrubbing, lift the scrub deck. Lift the rear squeegee (the vacuum motor will turn off after 10 seconds).
Move the machine to a service area for daily maintenance and review items that may need service.
2. Empty the solution tank by disconnecting the
solution tank drain hose
from the barb fitting and routing hose to a
drain. Rinse the tank with clean water to prevent any buildup of dried chemicals that could clog the plumbing.
3. Empty and clean the recovery tank by flushing with a hose. Be sure to also clean the float shut off screen.
4. Remove the
brushes
or pad holders and rinse them in warm water and hang to dry.
5. Remove the
rear
squeegee and recovery hose
, rinse with warm water and reinstall after cleaning (see page 13 for
correct hose installation).
6. Check the
maintenance schedule
in the next section and perform any required maintenance before storing the
machine.
7. Store the machine indoors in a clean dry place. Keep from freezing. Leave solution and recovery tank lids open for
ventilation to prevent odor buildup.
8. Turn
Key switch OFF (O)
and remove key.
