7
English
INSTALLATION PLACEMENT
This UPS series is intended to be install in a temperature controlled environment
that is free of conductive contaminants. Select a location which will provide good air
circulation for the UPS at all times. Avoid locations near heating devices, water or
excessive humidity, or where the UPS is exposed to direct sunlight. Route power
cords so they cannot be walked on or damaged.
INSTALLATION
Be sure to read the installation placement and all the cautions before installing the
UPS. Place the UPS in the final desired location and complete the rest of the
installation procedure. These UPSs are shipped with the internal batteries discon-
nected. The batteries must be connected before putting these UPSs into service.
See the Connecting The Batteries procedure to connect the batteries.
ENVIRONMENTAL
Operating/Storage Humidity:
95% Non-Condensing
Storage Elevation:
0 to 15,000m (0 to +50,000 ft)
Storage Temperature:
-15 to +45
°
C (+5 to +113
°
F)
Audible Noise at 1 m (3 ft.):
<45 dBA
Operating Temperature:
0 to 40 degrees C (+32 to +104 degrees F) at
Operating Elevation:
0 to 1,500m (0 to +5,000 ft)
Operating Temperature:
0 to 35 degrees C (+32 to +95 degrees F) at
Operating Elevation:
1501 to 3,000m (0 to +10,000 ft)
WALLMOUNTING
The wallmount configuration allows the user to mount the UPS on the wall. The
UPS's back panel has keyed mounting holes for attaching the UPS to the wall.
1. Once the location and position of the UPS has been determined, use the temp-
late to mark the screw hole position on the wall. CAUTION, you should always
were protective gear for your hands and eyes when operating power tools.
2. Attach the two retaining screws (provided) to the wall and make sure that the
retaining screws are screwed into structural material. Then clean the area of any
loose material. Do not tighten the retaining screws all the way in, leave approxi-
mately 3/16" of the retaining screws sticking out.
3. Position the UPS, so that the keyed mounting holes line up with the two retaining
screws. Slide the UPS down until it is resting securely on the retaining screws.
4. The Wallmount Configuration is complete. See Connecting your Equipment.
