6
BRUSH INSTALLATION - REMOVAL
INSTALLATION
1. Raise the scrubhead to the “UP” position by depressing the pedal (A) downward as
shown on Fig. 1.
2. Center brush (D) under the scrubhead shroud while lining up the center
hex drive hub and pressing the brush up until the brush engages on the drive hub.
REMOVAL
1. Raise the scrubhead to the “UP” position by depressing the pedal (A) downward as
shown on Fig. 1.
2. Remove the brush (D) by stepping on the “BRUSH RELEASE PIN”
on the top of the scrubhead shroud as shown on Fig. 1 below.
Figure 1
Summary of Contents for MC20003QP
