Using the machine on public roads and places is not admitted. Qualified personnel only are admitted to perform
maintenance and repair work .
Turn the machine off and disconnect the mains plug before cleaning and maintaining the machine, when replacing parts
or when change over to another function.
Do not clean the machine by means of vapour jet or high pressure cleaning equipment. Do not allow water
penetrate the electrical parts.
The machine is splash-water proof (IPX3).
Use of the machine in areas endangered by explosion hazard is not admitted.
Transport
The front roller of the Port A scrub 14 has been fitted for parking the machine only and precludes damages to the floor .It is
thus recommended to lift up the brush head as represented before transporting the Port A Scrub 14.
Park Position
If not operated, the Machine has to be stored in its park position. This position is attained by using the support roller
located at the front of the machine as represented. Actuate the support by a lever located above the support roller (see
Fig.) And the brush head of the machine is lightly lifted. This is to preclude deformation of the brushes.
6
Never collect explosive fluids, undiluted acids and solvents! This includes e.g. gasoline, paint thinners or fuel oil,
Which-when penetrating the air being taken in may form explosive vapors or mixtures; moreover acetone,
Undiluted acids and solvents if they should be aggressive to the material used for the machine components.
The machine may be used only on indoor hard floorings and for operation on level grounds with a maximum
inclination of up to 2 %
Make sure to connect the
to a socket equipped with earthed protective wire and to
mains of adequate voltage and frequency
Port A scrub 14
Handling Mains cable Assembly
Make sure that the mains cables are not damaged by passing over them by pinching, pulling or other impacts. Check the
mains cables for ageing and damages at regular intervals. Replace them by the type ST cable 14 AWG / 3 Core (UL / CSA
approved) with 15 m length. Power plug and connectors shall be rated for 125 Volts, 20 Amps (UL / CSA approved) having
standard NEMA configuration for locking types as specified by the manufacturer. When replacing the coupling plug of
the mains cable or when connecting lines respect the splash water protection and the tensile strength of the components.
Parking Position
Working Position
Summary of Contents for Port A Scrub 14
