16
Management: Device
This allows the administrator to configure the outlet name, the delay time and setup different users for specific
outlets.
Outlet Configuration
Outlet Name:
Rename the outlet.
Delay ON:
Set the delay time in seconds for the power on sequence.
Delay OFF:
Set the delay time in seconds for the power off sequence.
After Restart:
Set the desired status you want the outlet to be after the outlet has been restarted.
Owner:
The administrator can setup different users for specific outlets. The user accounts must be setup first,
see the Configuration User tab.
Click Apply to save the settings, once the setup is complete.
Note:
The maximum delay times are 9999 seconds.
Energy Configuration
Carbon Emission Rate:
Set the Carbon Emission Rate and then select Apply to saving the setting.
Note
：
After the RPM is plugged into the main power, the RPM will automatically start to sequentially turn on the outlets
according to the preset delay time. The default setting for delay time is one second for each outlet; therefore the 8
outlet RPM will take 8-seconds to complete the start-up sequence.
If the RPM is unplugged from the main power before the start-up sequence is completed, the outlets, which were
not turned on will remain off. The next time the RPM is plugged into the main power, these outlets will not be
automatically turned on. These outlets can only be turned on via the web interface.
