3
www.everik.com
BTH200.KM.072013.IM
Note:
Pairing mode will last 2 minutes. If not devices can be connected after 2 minutes, it will return to standby mode automatically.
5. Making calls
Function
Status of BTH100
Operation
Cancel calling
Calling
Press MFB button once
Answer a call
Incoming ring
Press MFB button once
Reject a call
Incoming ring
Press and hold MFB button for 2 seconds and release it until hearing
indication tone
End a call
During a call
Press MFB button once
Volume up
During a call
Press
+
button
Volume down
During a call
Press
－
button
Call transfer (cell phone to headset)
During a call
Press
MFB
button for 2 seconds
Microphone mute
During a call
Double click
MFB
button
Cancel mute
During a call
Double click
MFB
button
Voice dial
Standby mode and connected to a device
Press < button about 2 seconds and release it until hear a prompt tone
Redial last number
Standby mode and connected to a device
Double click
MFB
button
6. LED indicator
A. Charging
LED Indicator
Status of headset
Red LED on
Charging
Red LED off
Finish Charging
B. Pairing with Bluetooth device
LED Indicator
Status of headset
Red and blue LED flashes alternately
Pairing mode
Blue LED flashes once quickly every 2 seconds
Not connect device
Blue LED flashes twice quickly every 4 seconds
Have already connected HFP or A2DP
Blue LED flashes three times quickly every 4 seconds Connect HFP and A2DP simultaneously
Blue LED flashes quickly
Calling/incoming call
Blue LED flashes once quickly every 4 seconds
During a call
Red LED flashes twice every 30 seconds
Low battery
7. Indication tone
Indication tone
Status of the headset
Continuous two prompt tone every 10 seconds
Conversation mode and microphone mute
Three “dong” warning tone every 20 seconds
Low battery
8. Factory Reset
In turned off mode, press and hold MFB and volume up “+” button about 8 seconds, you will see red LED on 1 second and hear two tones.
After factory reset, the paired list of devices will be deleted.
