Mira Element SLT, Installation And User Manual

11

Screws

Outlet Pipe to Fittings

Hot Supply

Cold Supply

Shroud Screw

F13125

Finished Wall

Min

Max

Minimum finished 

wall surface

Maximum finished 

wall surface

13.

 Turn on the water supplies and check for 

leaks.

14.

 Remove the two shroud screws and refit the 

building-in shroud to the mixer.

15.

 Using the ‘Finished Wall Indicator’ on the 

building-in shroud as a guide, finish the wall, 

e.g. tiles.

Caution!

  Make  sure  that  the  finished  wall 

is within the maximum and minimum limits 

and to an even depth (no greater than 2 mm 

variation) or the control components will not fit 

correctly.

16.

 Remove the building-in shroud and secure 

the chrome trim to the mixer using two of the 

bracket securing screws.

17.

 Fit the concealing plate and control assembly, 

refer to section: 

‘Control Assembly’

.

6.

  Make sure that the mixer is level and central 

in  the  hole  and  square  to  the  finished  wall 

surface (or the control components will not fit 

correctly), then mark the positions of the fixing 

screw holes on the wall.

7.

  For solid walls drill two Ø6 mm holes for the 

wall plugs.

8.

  Fit the hot and cold supply pipes (

Hot - Left, 

Cold - Right

).

9.

Caution! It is essential at this point 

that the supply pipework is thoroughly 

flushed through before connection to the 

mixer.

 Failure to do so may result in product 

malfunction and will not be covered under the 

guarantee.

10.

 Insert the wall plugs and attach the mixer to 

the wall with the screws provided.

Note!

 For stud partition installations alternative 

fixings may be required (not supplied) to fix the 

mixer to the rear face of the wall cavity or to a 

timber noggin.

11. 

Make sure that the olives are fitted and connect 

the hot and cold supply pipes, then tighten the 

compression nuts.

12. 

Connect the outlet pipework and install the 

RAC assembly or BIR assembly, 

before 

continuing with the installation of the mixing 

valve.

RAC assembly

, go to section: ‘I

nstallation, 

RAC Assembly’

.

BIR assembly

, refer to your shower fittings 

installation and user guide then continue with 

instruction 13.