Mira Element SLT, Installation And User Manual

12

Panel Fixing using Securing 

Brackets

Note!

 For laminated panels the mixer must be 

positioned from the rear of the panel.
Panel thickness must be between 4 and 12 mm 

(if a thicker panel is used, it will be necessary 

to recess the securing brackets into the rear of 

the panel).

Important!

 Make sure that there is a minimum 

clearance of 64 mm behind the laminated panel 

to conceal the mixer.

1.

  Refer to section: 

‘Solid Wall or Stud Partition 

Fixing using Rear Mountings’

 and follow 

build instructions 1 to 4.

2. 

Carefully cut out the laminated panel.

3. 

Fit the securing brackets to the mixer.

Important!

 The securing brackets must be 

fixed vertically, as illustrated.

Important! 

Make sure that the correct holes 

are used, otherwise the backplate cannot be 

fitted.

4.

  Position the mixer on the front of the panel, 

make sure that it is level and central in the 

hole, then mark the position of the M5 fixing 

holes.

Important!

 Make sure that the correct holes 

are used (refer to illustration).

Note!

 Make sure that the Filter Plugs are 

positioned so that they can be removed for 

servicing.

5.

  Drill  the  two  Ø5.5  mm  holes  for  the  fixing 

positions (countersink the holes at the front).

6.

  Fit the hot and cold supply pipes (

Hot - Left, 

Cold - Right

)

M5 Fixing Hole

M5 Fixing Hole

Backplate 

Securing Hole

Backplate 

Securing Hole

Filter Plug

Hot Supply

Cold Supply

Outlet Pipe to 

Fittings

M5 x 40 mm 

Fixing Screws

7.

Caution! It is essential at this point 

that the supply pipework is thoroughly 

flushed through before connection to the 

mixer.

 Failure to do so may result in product 

malfunction and will not be covered under the 

guarantee.

8.

  Secure the mixer with the M5 x 40 mm screws 

as shown.

9.

  Make sure that the olives are fitted, connect 

the hot and cold supply pipes and tighten the 

compression nuts.

10. 

Connect the outlet pipework and install the 

RAC assembly or BIR assembly, 

before 

continuing with the installation of the mixing 

valve.

RAC assembly

, go to section: ‘I

nstallation, 

RAC Assembly’

.

BIR assembly

, refer to your shower fittings 

installation and user guide then continue with 

build instruction 11.

11.

 Turn on the water supplies and check for 

leaks.

12.

 Fit the concealing plate and control assembly, 

refer to section: 

‘Control Assembly’

.