Mira Element SLT, Installation And User Manual

17

2.5 mm 

Hexagonal Key

Lever Insert

Hinge

Pin

Lever 

Insert

Eco Flow 

Device

Swap positions.

i.e. Refit Lever 

Insert where Eco 

Flow Device was 

originally.

Cartridge Seal

6.

  Remove the dome shroud, bearing and 

chrome trim if fitted (Built in Models only).

7.

  Fit the multi tool onto the cartridge nut and 

turn anticlockwise. Unscrew fully and pull the 

cartridge from the mixer body.

8.

  Use the 2.5 mm hexagonal key or a suitable 

sized screw driver to push the hinge pin from 

left to right, releasing the lever insert (refer to 

illustration). 

9. 

Repeat the procedure to remove the eco flow 

device.

10. 

Rotate the cartridge 180°.

11. 

Refit the eco flow device in the location that 

the lever insert was originally removed from, 

pushing the hinge pin in from right to left.

13.

 Make sure that the two cartridge inlet seals 

are fitted and carefully push the cartridge into 

the body, aligning the cartridge lugs into the 

body slots.

Note!

 Check that the cartridge lug stamped 

‘H’ is aligned with the hot inlet supply.

Important! 

Take care when fitting the cartridge 

as damage to the cartridge inlet seals may 

result in dripping from the shower head.

14. 

Tighten the nut by turning the multi tool 

clockwise. 

Note! 

Please ensure it is tightened fully.

15.

 Reassemble in reverse order.

16. 

Before using the Shower, refer to section: 

‘Commissioning’

.

Lever 

Insert.

Lever Insert 

must

 re-engage 

correctly.

12.

 Repeat the procedure to refit the lever insert 

making sure that it re-engages correctly with 

the cartridge.

Note! 

When the pin is fitted correctly it will be 

flush with the Lever Insert.