Mira Element SLT, Installation And User Manual

9

14.

 Fit  the  shower  fittings,  refer  to  your  shower 

fittings installation and user guide for 

instructions.

Note!

 For high pressure systems (above 

0.5  bar)  make  sure  that  the  flow  regulator 

(supplied) is fitted inside the outlet nipple (refer 

to illustration).

Important! 

The fitting of this flow regulator will 

invalidate any TMV2 low pressure compliance 

due to the minimum flow rate requirements. Do 

not fit the flow regulator in TMV2 low pressure 

applications.

15.

 Turn on the hot and cold water supplies and 

check for leaks.

16.

 Before using the shower, refer to section: 

‘Commissioning’

.

6.

  Remove the backplate from the mixer by 

loosening the grubscrew with a 2.5 mm 

hexagonal key.

7.

  Secure the backplate to the wall using the 

screws.

8.  For Rear Entry Supplies Only:

Fit the concealing plates over the inlet pipes.

 Note!

 Apply silicone sealant to the back face 

of the flange.

Apply Silicone Sealant

Concealing Plate

9.  Caution! It is essential at this point 

that the supply pipework is thoroughly 

flushed through before connection to the 

mixer.

 Failure to do so may result in product 

malfunction and will not be covered under the 

guarantee.

10.

 Fit the compression nuts and olives onto the 

pipework.

11.

 Align the mixer with the pipework and fit onto 

the backplate.

12.

 Tighten the compression nuts onto the mixer 

with a suitable spanner.

Caution!

 Take care not to damage the chrome 

surfaces.

13.

 Tighten the grubscrew to secure the mixer to 

the backplate.

Note!

 Make sure that the flow regulator (supplied) 

is fitted inside the outlet nipple in the orientation 

shown.

Flow Regulator