12
13
X
Turning off: Press and hold upper
or lower part of the rocker switch
for several seconds. A power down
melody is played.
See also the tips for charging in the charger’s user
guide.
Switching to standby mode
Via remote control or the Miracle-Ear
®
App, you can
switch your hearing aids to standby mode. This mutes
the hearing aids. When you leave standby mode, the
previously used volume and hearing program are set.
Note:
●
In standby mode, the hearing aids are not turned off
completely. They draw some power.
Therefore we recommend to use standby mode
only for a short period of time.
●
If you want to leave standby mode, but the remote
control or app is not at hand: Turn your hearing
aids off and on again (via rocker switch or by shortly
placing them in the charger until one or more
orange LEDs light up). In this case, the default
volume and hearing program are set.
Inserting and removing the hearing aids
Your hearing aids have been fine-tuned for your right
and left ear. Colored markers indicate the
side:
●
Red marker = right ear
●
Blue marker = left ear
Inserting a hearing aid:
X
Hold the tube close to the ear piece.
X
Carefully push the ear piece
into the ear canal .
X
Twist it slightly until it sits
well.
Open and close your mouth
to avoid accumulation of air
in the ear canal.
X
Lift the hearing aid and
slide it over the top of
your ear .
CAUTION
Risk of injury!
X
Insert the ear piece carefully and not too
deeply into the ear.
