Miranda ADX-102i, Manual To Installation And Operation

2 

2   Installation 

2.1   Unpacking

Make sure the following items have been shipped with the ADX-102i/104i/108i.  If 
any of the following items are missing, contact your distributor or Miranda 
Technologies Inc. 
 

•

  ADX-102i, ADX-104i or ADX-108i Digital Audio Demultiplexer 

•

  Rear panel labels 

•

 This 

manual 

2.2   ADX-102i/104i/108i Mechanical Installation

Due to its audio outputs, the ADX-102i/104i/108i must be mounted within Quartet-
A-75 or Quartet-A-110 or Symphonie 

imaging

 frame using Symphonie-R-CX, 

Symphonie-R-A75, Symphonie-R-A110 or Symphonie-R-AX rear modules.  This 
section describes how to install the ADX-102i/104i/108i in any of these frames.  It 
is not necessary to switch off the power from these frames when installing or 
removing the ADX-102i/104i/108i.   
 

2.2.1   Quartet-A-75 and Quartet-A-110 Frame

 
To install this module into the audio Quartet frames follow these steps.  For a 
closer look at module installation and removal, refer to the frame's 

Guide to 

Installation and Operation

. 

 
1.  Remove the frame's front panel by rotating the thumb screws counter-

clockwise.  Pull on the handles. 

2.  Select an empty slot. 
3.  Carefully place the ADX-102i/104i/108i between a set of module guides and 

gently push the module towards the rear of the frame until the module's edge 
connector is secured to the backplane.  Pull lightly on the module verifying that 
it does not move. 

4.  Replace the frame's front panel.  Make sure to rotate the thumb screws 

clockwise in order to secure it to the chassis. 

2.2.2   Symphonie Frame

 
To install this module into the Symphonie housing frame, follow these steps. To 
function, the ADX-102i/104i/108i requires the Symphonie-R-CX, -R-A75,-R-A110 
or -R-AX rear module. For a closer look at module installation and removal, refer to 
the frame's 

Guide to Installation and Operation

.   

 
1.  Remove the front panel door by pulling on the door handles and gently 

lowering it. 

2.  Select an empty slot. 
3.  Carefully place the module between the module guides and slowly push the 

module towards the rear of the frame until the module's edge connector is 
secured to its rear module.  A light pressure to mate the connectors may be 
required.  Pull lightly on the module verifying that it does not move.   

4.  Replace the front panel door.