GUIDE TO INSTALLATION AND OPERATION
4
| CPU-ETH2
8. Push
ESC
until you are back at the main menu, and then push the
CONTROLLER
button again to exit the menu
system and save your changes.
Note that if you do not use the controller buttons for thirty seconds, the process will time out, so have your data ready
to enter when you start.
4 Local Control Operation
Push the CONTROLLER button on the local control panel to assign that panel to operate the CPU-ETH2 controller.
Use the control panel buttons to navigate through the menu, as described in 2.2 above.
The menu is discussed and displayed beginning on page 16.
5 Remote Control Operation
This card supports remote operation through two rear-panel 10/100 Base-T ethernet ports, using Miranda’s iControl or
a third-party solution. The command set available for communicating with a DENSITÉ frame permits more complex
and comprehensive control, parameter storage, and field upgrading than is supported by the local control panel.
Miranda’s iControl solution gives access to the settings and adjustments for the CPU-ETH2 controller card in a
Densité frame, and also to these features for all cards installed in the frame. For that reason, the iControl interface is
used as the primary reference to describe the set-up and operation of the CPU-ETH2.
5.1 CPU-ETH2 Web Page
However, the CPU-ETH2 also serves a web page which provides an alternate means of configuring the card. The
web page does not give access to controls for other cards in the frame, however.
The web page is the only point of access for upgrading the CPU-ETH2 firmware – this function is not supported under
iControl, or via the local control panel.
See section on page for instructions on accessing the web page and upgrading the CPU-ETH2 firmware.
5.2 iControl Interface
The operation of the CPU-ETH2 card can be controlled using
Miranda’s iControl system. This manual describes the control
panels associated with the CPU-ETH2 and their use. Please
consult the iControl User’s Guide for information about setting
up and operating iControl.
In iControl Navigator or iControl Websites, double-click on the
icon of the controller to open its control panel.
•
CPU-ETH2 controllers are identified as Controller2 in the
Type column of the iControl Navigator window.
•
For convenience, enter a descriptive Label in the Info
panel of the card, to make it easy to locate this specific
frame controller amongst those in the list. See page 5.
USO
RESTRITO
