Kaleido-X16
Hardware Description & Installation Manual
51
When the ABT is powered up, all three LEDs will be orange until the boot sequence is terminated. This is a
visual indicator that the LEDs are functioning properly.
Controls
The RESET button is located on the right-hand side of the ABT rear panel.
Push the RESET button to reset the ABT's IP address to a default value:
• IP address:10.0.3.190
• Subnet mask:255.255.0.0
This simplifies the process of connecting to the ABT via its Ethernet connection.
Operation
Synchronization
An external reference signal is required to synchronize the SDTI outputs. An analog video reference signal,
word clock or AES-75 signal can be connected to one of the REFERENCE SIGNAL connectors. If the loop-
through is not used, a 75 ohm termination on the other REFERENCE SIGNAL connector must be used to
properly terminate the line.
For an Audio Bridge Terminal with an AES breakout panel, AES INPUT 1 can also be used for
synchronization. This input signal must be error-free PCM audio sampled at 48 kHz. In the case where both
REFERENCE SIGNAL and AES INPUT 1 have valid references, the signal connected to REFERENCE SIGNAL has
priority.
SDTI Link
The two SDTI outputs are identical, each including signals from all inputs. Each SDTI output can be
connected to a Kaleido-X16 input module or to a specific SDTI de-multiplexer. Depending on the number
Orange
Warning
Flashing Orange
Warning, rebooting
Red
Hardware fault
Flashing Red
Upgrading firmware
See also:
For more information about connecting to the ABT with a Web browser, see “Web Interface” on
page 52.
Color
Board Status
Summary of Contents for Kaleido-X16
Page 4: ......
Page 32: ...26 Kaleido X16 Installation Replacing a Defective Power Supply 1 ...
Page 80: ...74 Specifications Physical Dimensions 3 ...
Page 82: ......