NV9604 Control Panel • User’s Guide
19
4. Configuration
Button Definitions
Four such modes (or behavioral models) apply. These letter codes identify, below, the NV9602
modes in which a button can operate:
S
—
single-destination mode
B
—
single-destination mode with breakaway
X
—
limited X-Y mode
M
—
multi-destination mode
Any
—
any mode
When the NV9604 is used by itself, the NV9604 has no modes, but can operate either as single-des-
tination panel (using the default destination) or as an X-Y panel.
Button Types
These are the button types available for NV9604 configurations:
Type
Modes Description
Destination
X
The button selects a destination.
When the panel is an NV9602 extension, the destination name appears in
the ‘Destination’ display of the NV9602. The destination is the target of
a pending take, which will route a source to that destination.
The nature of destination buttons differs according to your configuration:
• Stand-alone panel.
When you assign a source button, one drop-down menus appear:
‘Destination Device’.
• NV9602 extension (you have checked ‘Use as Slave Panel’).
When you assign a destination button, two drop-down menus appear:
‘Destination Device 1’ and ‘Destination Device 2’. These correspond
to the two destination sets. If there is a ‘Destination Shift’ button on
the NV9602 panel, the operator can switch between the two sets.
When the first set is selected, pressing the button selects device 1.
When the second set is selected, pressing the button selects device 2.
Note that when an NV9602 is in multi-destination mode, the only
operable buttons on the NV9604 are salvo buttons.
Previous
Source
S, B, X
The button presets the previously routed source to the currently selected
destination. The operator must next press ‘Take’ to restore the previous
route. This function is useful when an operator makes a route in error.
The button definition has no fields to configure.
The button does
not
restore the previous destination. If the user changed
the destination and presses ‘Previous Source’, the take will not restore
the previous route.
The button type is not available unless you have checked ‘Use as Slave
Panel’.
