GUIDE TO INSTALLATION AND OPERATION
6
| RCP-100
Case 2 (figure 3.5)
In this case, multiple RCP-100s are connected on the LAN. Only one of these can be configured as a
SERVER; all others must be configured as CLIENTs.
Figure 3.5
Multiple RCP-100 Installation
Here are the settings for this set-up, where:
•
the IP address of RCP-100 #1 (server) is 10.2.5.10
•
the IP address of Densité #1 is 10.2.5.11
•
the IP address of Densité #2 is 10.2.5.12
•
the IP address of Densité #3 is 10.2.5.13
•
the IP address of RCP-100 #2 (client) is 10.2.5.20
•
the IP address of RCP-100 #3 (client) is 10.2.5.21
Settings for RCP-100 #1 (server)
IPADDR: 10.2.5.10
SERVICE CONFIG – ICOM: ON
DCOM:
ON
DSRV:
ON
DSRV IP: 10.2.5.10
Settings for RCP-100 #2 (client)
IPADDR: 10.2.5.20
SERVICE CONFIG – ICOM: OFF
DCOM:
OFF
DSRV:
OFF
DSRV IP: 10.2.5.10 (the IP address of the server, i.e. RCP-100 #1)
Settings for RCP-100 #3 (client)
IPADDR: 10.2.5.21
SERVICE CONFIG – ICOM: OFF
DCOM:
OFF
DSRV:
OFF
DSRV IP: 10.2.5.10 (the IP address of the server, i.e. RCP-100 #1)
Within the ±5 IP address range
around the server IP address
Outside the ±5 IP address range
around the server IP address
reserved for Densité frames
