GUIDE TO INSTALLATION AND OPERATION
12
| RCP-100
4.3.2 Device
Locking
The protection provided by this feature is only meant as a safety measure to prevent accidental modifications
to a device configuration. It is not designed to provide a highly secure protection mechanism. It inhibits
control by the local panel. Other panels connected to the device may modify the device configuration while
the local panel is locked out.
A given device has one of the two (2) following states:
State
Description
Unlocked
Device parameters can be modified by the local panel.
Locked
Device parameters cannot be modified by the local panel.
The lock feature is enabled via the <DEVICE LOCK> key available in device selection mode. An icon on the
LCD display indicates the current state of protection.
If a device is locked, the rotary encoders are disabled while the RCP-100 is in operation mode. If they are
turned, the current display changes and the following message appears for 2 seconds:
DEVICE IS LOCKED
Lock status icon
LUMA|CHMA|GAIN|SETUP
1.00|1.00|LOCK|7.50
To change the protection state of a device:
• Press the <Device> button to enter the device selection mode (LED is GREEN);
• Press the <DEVICE LOCK> key;
• Turn the first knob to select either lock or unlock;
• Press the <Device> button again to select the device.
4.3.3 Panel
Configuration
The RCP-100 may exist on an ethernet network, and must therefore conform to the appropriate addressing
protocols. The panel set-up is accessed from the CONFIG function key.
Pressing the CONFIG key results in:
IP ADDR: Sets the IP address for this RCP-100. The LCD display shows:
IP ADDRESS
192.168.210.1
192 | 168 | 210 | 001
