Introduction
2
Keypad Navigation
The diagram below shows how to use the keypad when in programming mode. It applies to both
Scrolling and Non-Scrolling Directory keypads.
Entering Programming Mode
To make changes to either scrolling or non-scrolling directories, you must first enter programming
mode.
Note:
If you are programming a function and do not enter information for three minutes,
the display will return to the programming menu without saving your changes. If
you are in the programming menu for 3 minutes, the display will return to the main
screen.
Note:
Before programming the system, make sure you have filled out the Resident
Directory Worksheet on page 29.
Entering Programming mode
1.
Press .
2.
Enter the password.
• If you
have
not
set a personal password,
press
(ten-digit factory default).
• If you
have
set a personal password, enter your 10-
digit password.
You are now in programming mode.
3
5
4
7
9
0
8
Press
to enter a
record when in
edit
mode
or to delete a
record when in
delete mode
In the
programming
menu
, press
to
scroll up.
In
programming mode
,
press
to
exit
without saving (
does not
apply to edit or delete
modes
).
In the
programming
menu,
press
to
scroll down.
In
programming mode,
press
to save your
changes and continue
(
does not apply to
delete mode
).
Press
to exit the
edit or delete mode
9
Press
to select an item in
the
programming menu
0
Enter the Password
[_ _ _ _ _ _ _ _ _ _]
9
9
9
9
Summary of Contents for TAS-2000 Series
