Installation overview
General
• Connect the 48 VDC power supply to the motor drive (J2 connector).
• Connect the tool to the motor drive (J3 connector).
Modbus RTU interface
• Use the J1 connector to connect the motor drive to the Modbus RTU bus.
Profinet I/O gateway to Modbus RTU interface
• Connect the 24 VDC power supply to the gateway and connect the DSUB-9 adapter cable between the gateway (X2
connector) and the motor drive (J1 connector).
Digital control interface
• Use the J6 connector to connect the common GND between the systems.
• Use the J5 connector to select the operation using the four digital input signals.
Relay interface
• The N/O relay pins are available on the J4 connector.
Component spare part codes
Mirka code
Name
MIA6513211
Power supply 48 V
MIA6513411
Power supply 24 V
MIA6513311
Hilscher NT 50-RS-EN
MIA6514011
Hilscher NT 50-RS-EN adapter cable
MIA6513112
Motor drive
MIA6512311
Shielded cable for tool (10 m)
Technical data for motor drive
Input
48 VDC
Nominal input voltage
46 - 50 VDC
Input voltage range
4
en (original)
