Description
PIN
Connector
P-
P-
J3
NTC+
NTC+
J3
Phase A
Phase A
J3
Phase B
Phase B
J3
Phase C-
Phase C
J3
GND
GND
J3
NTC-
NTC-
J3
Description
PIN
Connector
Relay COM
COM
J4
Relay NO
NO
J4
Description
PIN
Connector
Digital spped control input bit 1
DI1
J5
Digital spped control input bit 2
DI2
J5
Digital spped control input bit 3
DI3
J5
Digital spped control input bit 4
DI4
J5
Description
PIN
Connector
15 VDC output
15V
J6
GND
GND
J6
Button description
Description
Button
Self-test button
S1
Reset button
S2
Indicator description
Description
Indicator
Speed set-point indicator, lit if ≥ 4,000 rpm. Modbus RTU slave address indicator, bit 1.
D2
Speed set-point indicator, lit if ≥ 5,000 rpm. Modbus RTU slave address indicator, bit 2.
D3
Tool status indicator. Lit red when the tool is stopped, lit green when the tool is running.
D4
Motor drive state indicator. Lit green when motor drive is in ON-state. Blinking green when
motor drive is in OFF-state.
D14
Speed set-point indicator, lit if ≥ 6,000 rpm. Modbus RTU slave address indicator, bit 3.
D17
Speed set-point indicator, lit if ≥ 7,000 rpm. Modbus RTU slave address indicator, bit 4.
D18
Speed set-point indicator, lit if ≥ 8,000 rpm. Modbus RTU slave address indicator, bit 5.
D19
Speed set-point indicator, lit if ≥ 9,000 rpm. Modbus RTU slave address indicator, bit 6.
D20
Speed set-point indicator, lit if ≥ 10,000 rpm. Modbus RTU slave address indicator, bit 7.
D21
Modbus RTU slave address indicator, bit 8.
D22
Lit if D2–D3, D17–D22 indicator mode is Modbus RTU slave address.
D23
Lit if digital speed control interface is enabled.
D24
Lit if the alarm status flag is set.
D25
Relay status indicator.
D26
Modbus RTU receive indicator.
D29
Modbus RTU transmit indicator.
D30
7
en (original)
