TROUBLESHOOTING
During house ID binding, the LED is not flashing on some
wireless devices.
• If LED is solid green before initiating house ID binding:
The device already has another house ID. Reset it to the factory default so
that it can be bound to the desired house ID. Resetting to factory defaults is
described in the “I need to start over” issue.
• If LED is solid yellow after initiating house ID binding:
The device may be out of range of the initiating device. Add a MRR2
Wireless Repeater to boost signal range.
During scene button or paddle binding, all LEDs stop flashing before
I get back to the MRH5 to press
The 10 minute house scene binding process timer may have expired.
Restart the binding process timer by repeating steps 1 and 2 of the procedure
you were using. Notice that the devices you previously included are flashing
yellow; simply finish the process from where you left off.
The device LED flashes red when I press .
The house or room configuration may be locked. Go to any house scene
controller and simultaneously press and buttons B and E until the scene
controller LED flashes GREEN. (See LOCK HOUSE CONFIGURATION.)
Go back to the previously locked device and press .
• If it flashes green or yellow, you have successfully unlocked
the house configuration.
• If the device still flashes red, the configuration may be locked
by a room level scene controller such as the MRD6 or MRH6.
See the room scene controller instructions for information on
unlocking the room configuration.
I made a configuration mistake. I need to start over.
To reset any Miro wireless device to factory default settings, press and hold
- - until the LED changes to solid yellow (approximately 10 seconds). During
the process, the LED flashes yellow. When complete, it becomes solid yellow.
The device can then be reconfigured, exactly like any new device.
