!
!
!
!
!
!
Turn the bathtub upside down. Make sure the floor is
protected by clean, padded material to avoid bathtub
surface damaging through the contact with the floor.
Mix 2 part of epoxy cement according to the
manufacturer’s instructions or use construction
adhesives
Place a generous portion of the cement onto each of the
supporting legs of the bathtub.
Turn the bathtub the right way up, center the bathtub on
the outline marked on the floor in the previous steps and
press down firmly
Leave tub for 12 hours to set
Finish the installation by running a bead of high quality
silicone around the outside of the bathtub, where the
bathroom floor meets the bathtub skirt.
.
2
FREE STANDING TUB INSTALLATION INSTRUCTION
Bathtub Leg
Two Part Epoxy
Cement
Tiles
Subfloor
(Plywood)
INSTALLATION CLEAN-UP
MAINTENANCE
It is important to remove all construction debris and foreign
material.
Remove construction dirt and residue with a mild liquid
detergent.
DO NOT USE abrasive cleaners, scouring compounds and
pads, metal scrapers, steel wool, or other materials that
could damage or dull the surface of the bath.
Remove plaster carefully with a blunt wooden block having
rounded edges.
Remove paint and other stubborn stains with isopropyl
(rubbing) alcohol.
DO NOT USE products such as acetone (nail polish
remover), dry cleaning solution, lacquer thinners, gasoline,
pine oil, etc.
Test the installation after completing the plumbing, but before
enclosing the bath and finishing the surroundings.
Fill the bath with water and leave it for one hour to ensure that
the adjustment of the drain-overflow assembly is correct, and
that there are no leaks.
The acrylic sheet, which forms the surface of your bathtub,
provides one of the most durable surfaces found in modern
bathrooms. Keep it bright and smooth with mild liquid
household detergent, soap and water, or foaming cleansers.
NEVER USE aromatic solvents, abrasive cleaners, scouring
compounds or pads, strong liquid cleansers, or other
material that could damage or dull the surface of the bath.
We recommend the use of Mirogloss Acrylic and Fiberglass
Polish before use and then periodically to preserve the
appearance of your bath. Mirogloss is available from your
Mirolin dealer.
- Restore surface gloss by
applying a very fine rubbing compound and polishing the
surface by hand or with a power buffer. Finish with an
application of Mirogloss or a good quality automotive wax.
- Remove minor scratches and
scuffs as follows. First, wet sand the area with 600 grit wet
sandpaper until the surface is smooth. Then, restore the
gloss as described under
TEST
Restoring Surface Gloss
Minor Repairs to Surface
RESTORING SURFACE GLOSS.
®
®
®
R
TM
60 Shorncliffe Rd., Toronto, Ontario M8Z 5K1
Telephone: (416) 231-9030 - Fax: (416) 231-0929
Customer Service:
(416) 231-5790
1-800-
(647-6546)
Fax, Canada: 1-800-463-2236
MIROLIN
23 Dec. 2010
We want you to be completely satisfied with our products and service. If you have any comments or suggestions, please call
toll free.
1-800-MIROLIN
INSTALLATION USING EPOXY CEMENT
Reference-FIGURE1
!
!
Locate the leveled tub in a place where it is to be installed.
Mark the outline of the tub on the floor by tracking along
the bottom of the apron.
Outline the Tub
Reference-FIGURE 2
