miseno MH00630AS, Installation, Use And Care Manual

10

1.  Measure from range top to hood bottom and mark line A.  

´PLQLPXPIURPUDQJHWRS

2.  Plum and mark center line.

 0DUNPRXQWLQJKHLJKWOLQH%´IURPOLQH$

4.  Mark mounting spread from C/L on line B. From center 

OLQHWROHIWPRXQWPDUN´)URPFHQWHUOLQHWRULJKW
PRXQWPDUN´

 )DVWHQ0[´VFUHZVLQWRVWXGVRQOLQH%'RQRW

fasten screws all the way.  

Note: wood blocking may 

need to be added behind the drywall if no studs are 
present.  Wall anchors may also be used but check 
local codes for compliance. Failure to use suitable 
wall anchors to hold the weight of the hood could 
result in personal injury or damage to the cooking 
surface or counter.

 +DQJKRRGRQWRVFUHZVDQGKDQGWLJKWHQ)LJ$8VH

the last M6x1-1/4” screw to further secure the hood to 
the wall from inside the hood.

7.   Center and attach duct cover bracket to wall below 

FHLOLQJRUVRI¿WXVLQJ0[´VFUHZV

8.   Install electrical.

9.   *Install duct work and duct tape.

10. Power up hood and check for leaks around duct tape.

11.  Place telescopic duct covers onto hood and extend 

LQQHUWRSGXFWFRYHUXSZDUGVDQGVHFXUHWRGXFWFRYHU
EUDFNHWXVLQJ0[VFUHZV

      *If using hood in recirculating mode you must secure air 

diverter plate onto wall before installing duct work and 
duct covers.  Turn to page 12 for more details.

A

B

C/L

12"

2"

C/L

26" min

fig. A

Duct Cover Bracket

3-1/2"

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.

!

Cable Lock

Cable Lock

$FDEOHORFNLQJFRQQHFWRUQRWVXSSOLHGPLJKW

be required by local codes.  Check with local 
requirements and codes, purchase and install 
appropriate connector if necessary.

CAUTION: At least two installers are

required due to the weight and size of the
hood.

!

Installation – 

Mounting the Hood MH006