miseno MH70130AS, Installation, Use And Care Manual

Installation – 

Mounting Height & Clearance

6

www.build.com

DUCTING

A minimum of 7” round or 3-1/4” x 10” rectangular 

duct must be used to maintain maximum air 

fl

 ow 

ef

fi

 ciency.

Always use rigid type metal ducts only. Flexible 

ducts could restrict air 

fl

 ow by up to 50%.

Also use calculation (on page 5) to compute total 

available duct run when using elbows, transitions 

and caps.

ALWAYS, when possible, reduce the number or 

transitions and turns. If long duct run is required, 

increase duct size from 7” to 8”. 

If turns or transitions are required; install as far 

away from hood duct output and as far apart, 

between the two as possible.

Minimum mount height between range top to hood 

bottom should be no less than 26”. 

Maximum mount height should be no higher than 

34”.

It is important to install the hood at the proper 

mounting height. Hoods mounted too low could 

result in heat damage and 

fi

 re hazard; while hoods 

mounted too high will be hard to reach and will 

lose its performance and ef

fi

 ciency.

If available, also refer range manufacturer’s height 

clearance requirements and recommended hood 

mounting height above range.

Vertical Ducting:

7” round minimum 

Horizontal Ducting:

3-1/4”x10” minimum

DAMAGE-SHIPMENT / INSTALLATION:

•  Please fully inspect unit for damage before 

installation.

•  If the unit is damaged in shipment, return the 

unit to the store in which it was bought for 

repair or replacement.

•  If the unit is damaged by the customer, repair 

or  replacement  is  the  responsibility  of  the 

customer.

•  If the unit is damaged by the installer (if other 

than the customer), repair of replacement must 

be made by arrangement between customer 

and installer.

9"

36"

96"

Min 26” - Max 34"