1
Set Up Guide
1. Unscrew large cap and add clean water to tank; Re-install cap (make sure
gasket seals)
2. Place tank on ground within 12’ of power source. Do not plug in at this #me
3. Unhook mister tubing from side of tank. Note: Mister heads are conven-
iently 10’ apart
4. Clip last mister head on far side of canopy or tent material
5. Posi#on second head so the tubing is as taught as possible
6. Con#nue in this fashion un#l you come to the tank
7. Remove shipping plug from pump (push ring at mouth of pump towards
pump and
simultaneously pull the tube out of it)
8. Make sure tubing end is clean and simply insert into the pump (push un#l it
bo2oms out)
9. Loosen small cap to tank (allows tank to breathe)
10. Remove power cord from mesh bag and plug into pump; then into power
source
11. Turn on switch (at the end of the adapter)
Enjoy Hours Of Cool Mis#ng Comfort!
Pack Up Guide
1. Turn off switch and unplug from power source (Coil cord and place into
mesh bag).
2. Unplug mister tube from pump (push ring at mouth of pump towards pump
and
simultaneously pull the tube out of it)
3. Let water drain from tubing before coiling to a 12” loop (Rea2ach to side of
tank)
4. Empty water from tank and replace large cap
5. Tighten small air breather cap
6. Turn on switch (at the end of the adapter)
Put Away Un#l Another Hot Day!
