12 GB
Installing the US fin (Fig. E)
Insert the metal plate
12a
in the hole in the mid-
dle of the slot and slide forward.
Note:
You can use the screw
12b
to slide the
plate along the slot.
Insert the back of the US fin
12
in the fin box
and slide back. Insert the front of the US fin
12
in the fin box and slide the US fin
12
forward
until the hole in the fin is located over the hole
in the metal plate
12a
.
Insert the screw
12b
in the hole in the fin and
screw it in along with the metal plate
12a
to
secure the US fin
12
.
Note:
Always ensure the fins are facing toward
you when carrying the board
1
. Be particularly
careful not to injure others with the board
1
in
windy conditions.
Assembling the single blade
paddle (Fig. K)
Loosen the locking lever
4a
on the extension
4
.
Insert the paddle shaft
3
in the extension
4
.
Extend the paddle shaft
3
to the desired
length.
Note:
For information about the recommended
paddle length, please see chapter ”Adjusting
the paddle length”.
Press in the locking lever
4a
on the extension
4
to lock the paddle shaft
3
.
Insert the paddle blade
2a
in the opening on
the extension
4
. Ensure the locking pin is in-
serted all the way in the pinhole on the paddle
blade
2a
. You must hear the pin on the exten-
sion
4
click into place when it locks into the
pinhole of the paddle blade
2a
.
Assembling the double-bladed
paddle (Fig. K)
Loosen the locking lever
4a
on the extension
4
.
Insert the second paddle blade
2b
in the end
of the extension
4
with the locking lever
4a
.
Turn the second paddle blade
2b
to the de-
sired angle.
Push in the locking lever
4a
on the extension
4
to lock the second paddle blade
2b
in place.
Insert the paddle blade
2a
in the opening on
the extension
4
. Ensure the locking pin in in-
serted all the way in the pinhole. You must hear
the pin on the extension
4
click into place
when it locks into the pinhole.
Disassembling the product
Select a clean, even surface with adequate
space to disassemble the product.
Disassembly requires the following steps:
·
Removing the US fin
12
and other accesso-
ries (foot rest
18
, seat
16
)
·
Releasing air from the board
1
·
Rolling up the board
1
·
Disassembling the paddle into the individual
parts
Note:
Remove the US fin
12
before releasing
air from the board
1
.
Removing the US fin:
Remove the US fin
12
per chapter ”Installing
the US fin” in reverse order.
Disassembling the paddle:
Disassemble the paddle per chapter ”Assem-
bling the single blade paddle” or ”Assembling
the double-bladed paddle” in reverse order.
Releasing air:
Place the dry board
1
flat on the ground and
open the two valves
1a
by pushing in the valve
needle
1b
whilst turning clockwise.
Only push the valve needle
1b
in slightly so air
can escape slowly.
Release the air.
You can alternatively use the air pump
13
to
fold the board
1
as flat as possible by attach-
ing the hose
14
backwards on the air pump
13
(Deflate). Connect the hose
14
to one of the
valves
1a
. The valve head must be down. Turn
the valve head to the right (Fig. C4), pump and
