MiTAC N653, User Manual

FCC 

Federal Communication Commission Interference Statement 
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to 

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.



Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the user's authority 

to operate the equipment. 
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 
Please note: 
The use of a non-shielded interface cable with this equipment is prohibited. 

IC 

Canadian Department Of Communications 
CAN ICES-3(B)/NMB-3(B) 
Radio Interference Regulations Class B Compliance Notice 
This Class B digital apparatus meets all requirements of the Canada Interference-Causing equipment 

regulations. 
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following 

two conditions: 

(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of

the device.

14