-33-
To answer a Direct Page when Handsfree Answerback is OFF, refer to
the following table:
To end a Handsfree Answerback call, do one of the following:
z
Hang up the handset to end a handset call.
z
Press
(SPEAKER) to end a handsfree call.
z
Press (CANCEL).
Note: When the Handsfree Direct Page call ends, the MUTE key light
returns to the state it was in before the call was established.
Phone state before
Direct Page arrives
To answer the Direct Page (indicated by a single
burst of tone)
Phone is idle, or you
are on a handset call,
and MUTE is OFF
1. Check that MUTE is ON solid.
2. Lift the handset OR press MUTE key to answer in
Handsfree mode.(The light turns OFF.)
3. Begin speaking.
Note: If you were on a handset call, your handset
microphone is still enabled.
You are on a MUTED
handset call, OR, you
are on a Handsfree call
The party paging you receives a busy tone. Handsfree
Answerback does not interrupt your call.
Summary of Contents for 5224
Page 1: ...USER GUIDE SX 200 ICP USER GUIDE ...
Page 2: ...SX 200 ICP 3 0 ...
Page 8: ... 2 The 5212 IP Phone ...
Page 9: ... 3 The 5224 IP Phone ...