74
Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015
Personalizing your phone
Setting the server alarm
Depending on the system’s settings, you can receive server alarms for specific situations.
These settings are made by your system administrator in the system. Contact your sys-
tem administrator for more information.
When the server alarms are activated in the system, you can select from the alarm signal-
ling as follows:
Vibracall
,
Progressive ring tone
,
Suppress ring tone
. A
List of melodies
(incl. the alarm melodies) is available to listen to.
Logging a cordless phone on/off
More information can be found in the chapter "Managing communication systems", page 84.
Linking the charging contact to direct call answer
You want to choose whether to answer a call simply by lifting the phone out of its charging
unit or whether you also need to press the Call key after lifting out the phone.
You can specify that your cordless phone should behave like a fixed phone when you
answer a call. In this case you do not have to press the Call key when you lift the phone
out of its charging unit.
Note:
Your settings for
Vibra call
and
Suppress ring tone
can be overruled by the alarm server.
Press the navigation key to the right or the
Menu
softkey.
Settings
Scroll to
Settings
and press the
Select
softkey.
Server alarm
Scroll to
Server alarm
and press the
Select
softkey.
<Server alarm setting>
Scroll to the server alarm setting you want and activate or deactivate it
with the
Select
softkey.
Press the navigation key to the right or the
Menu
softkey.
Settings
Scroll to
Settings
and press the
Select
softkey.
General
Scroll to
General
and press the
Select
softkey.
Direct call answer
Scroll to
Direct call answer
and activate or deactivate with the
Select
softkey.
➔
The setting is stored.
