Mitel 6869i SIP Phone Release 4.0.0 SP1 User Guide
126
6.
To receive RTP steams for group paging, you must also configure the
Paging Listen
Addresses
parameter at the path,
Basic Settings > Preferences > Group Paging RTP
Settings
. For more information about setting this parameter, see
“Group RTP Paging”
on
page 199
.
Expansion Module Keys
7.
Select from
Key 1
through
Key 16
(M680i)
or
Key 84
(M685i).
8.
In the
Type
field, select
Paging
.
9.
In the
Value
field, enter a multicast IP address and a port number for the Paging key. When
you press this key, the phone initiates an outgoing multicast RTP session to the specified
address using the specified port. (For example, 239.0.1.15:10000).
10.
To receive RTP steams for group paging, you must also configure the
Paging Listen
Addresses
parameter at the path,
Basic Settings > Preferences > Group Paging RTP
Settings
. For more information about setting this parameter, see
“Group RTP Paging”
on
page 199
.
11.
Click
Save Settings
to save your changes
USING THE PAGING KEY
The following procedure describes the use of the
Paging
key on the IP phone. The procedure
assumes you have already configured the
Paging
key using the Mitel Web UI.
1.
On the IP phone, press the softkey or expansion module key you configured for
Paging
.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen
displays.
2.
Press the
Drop
key to end the multicast RTP session and return to the
Home
screen.
Notes:
1.
When you select
Paging
for the
Type
field, the
Line
field is disabled.
2.
The
Value
field allows for one multicast address entry only.
Notes:
1.
The recipient of a paging call can set a global DND to ignore any incoming pages.
2.
For incoming paging, the phone uses the Intercom configuration settings. The
incoming page is dependant on the
Allow Barge In
parameter setting and the
idling/on call state.
IP PHONE UI
Note:
If you enable global DND on the phone, the incoming multicast RTP session is
dropped.
