Phoning
Mitel 6867 SIP / Mitel 6869 SIP
53
eud-1664/1.3 – R5.0 – 06.2017
The maximum recording time for each .wave file depends on the system
configuration. When the predefined or maximum recording time is
reached, the recording stops automatically, the file is sent to your e-mail
address and a new recording starts at the same time. Contact your system
administrator for more information.
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 97).
Notes:
• Recording calls may infringe on your national data protection provisions
or be permitted only under certain circumstances. If you intend to use
this function notify your call party in advance.
• You cannot record a conversation involving more than two call parties
(enquiry call, conference). The recording is automatically stopped if you
park your call party or put him on hold.
Activating discreet ring
You do not want to be disturbed by the ring of the phone. You do not, how-
ever, want to switch off the phone.
As an alternative to the usual ring, your phone has a discreet ring option. If
you have activated discreet ring, the phone only rings once.
This function must be saved to a function key over the Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 97).
Recording a call:
Press the function key for
Call recording: start/stop
as soon as you have an
incoming/outgoing call or an active call.
➔
The discussion is recorded and the LED on the function key is switched on.
Stopping the call:
End the recording by pressing the function key
Call recording: start/stop
again.
➔
The recording is sent to your e-mail address.
Note:
The LED on the function key remains lit while the recording is in progress. The
LED starts to flash before the recording reaches its maximum preset duration.
Once the maximum duration is reached (or the memory is full), the recording is
stopped and the LED goes off.
