Setup
5
SETUP
In preparation for the measurement session and to optimize battery life time, all components
should be fully charged. The Powerpack, Mitel 650 DECT phone and iPod should be switched
off before being stored in the carrying case and for longer breaks between measurement
sessions.
DECT BASE STATION SET UP
Setting up the RFP SI (with internal antennas)
1. Install the tripod (light stand).
2. Attach the Powerpack in bracket.
3. Connect the PoE cable to the Powerpack (use the standard
RJ45 connector).
4. Screw the DECT base station mounting plate on the tripod.
5. Attach RFP SI (with Status-LED’s 1-2-3-4 bottom-up).
6. Connect the PoE cable to the DECT base station via the RJ45
field plug.
7. Switch the Powerpack ON.
• Short press on button with a pin turns the Powerpack ON (RJ45 LED
is green)
• Long press on button turns the Powerpack OFF (RJ45 LED is off)
8. Wait for the DECT base station (RFP SI) to come up.
LED state (bottom-up): 1+2 alternate green/orange, 3= green if DECT-ready, 4=off (only for
WLAN).