TA7102 Hardware Installation
16
153/1531-ANF 901 14 B 2017-03-08
Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip to earth
ground to channel unwanted ESD voltages to ground safely.
3.3
REQUIRED MOUNTING TOOLS AND EQUIPMENT
You will need the following tools and parts to properly install the TA7102:
Screwdriver as required for attaching brackets to rack or wall.
Screws and anchors for wall-mounting, if required.
Four wood screws or other fasteners, for installing the chassis on a wall.
ESD-preventive wrist strap.
In addition, you might need the following external equipment:
Modem for remote access.
RJ-45 cables for the WAN and LAN connections.
3.4
UNPACKING AND INSPECTION
If you haven’t already done so, unpack the TA7102 device. Carefully remove it from the package and
packing material. The TA7102 package contains the following items:
1 x TA7102 unit
1 x power cord for the country in which you are using the TA7102
1 x universal power supply
1 x 10/100 BaseT Ethernet RJ-45 cable
1 x Printed Flyer
You may also need additional 10/100 BaseT Ethernet RJ-45 cables.
3.5
LOCATION AND MOUNTING REQUIREMENTS
Warning:
The analog lines of the TA7102 are not intended for connection to a telecommunication
network that uses outside cable.
Warning:
To prevent fire or shock hazard do not expose the unit to rain or moisture.
The TA7102 is suited for use in an office or residential environment where it can be wall-mounted or free
standing.
Location
Install the TA7102 in a well-ventilated location where it will not be exposed to high temperature or
humidity. Do not install the TA7102 in a location exposed to direct sunlight or near stoves or radiators.
Excessive heat could damage the internal components.
When deciding where to position the TA7102, ensure that:
The TA7102 is accessible for future upgrade, maintenance and troubleshooting, and cables can be
easily connected.