TA7102 Hardware Installation
18
153/1531-ANF 901 14 B 2017-03-08
Wall-Mounting
To wall-mount the TA7102:
1. Disconnect all of the cables from the TA7102 before mounting.
2. Ensure that the wall you are using is smooth, flat, dry and sturdy. Attach a piece of plywood,
approximately 250 mm x 200 mm x 12 mm (10 inches x 8 inches x 0.5 inches) securely to the
wall, if necessary.
3. Position the TA7102 against the wall (or plywood) as illustrated in Figure 4.
Figure 4:
Bottom View - Wall Mounting Screw Holes
Rear
Screw holes
Front
You can position the TA7102 any way you want.
4. Mark the position of the screw holes on the wall. Drill the two holes and install two screws.
5. Place the screw holes of the TA7102 over the screws installed in the previous step.
6. Proceed to
Hardware Installation.
Free Standing Unit
When installing the TA7102 on a desk or table, it should be located at least 20 cm from your monitor,
computer casing or other peripherals, including speakers. Never put books or paper on the TA7102.
