TA7102 Hardware Installation
20
153/1531-ANF 901 14 B 2017-03-08
3.6
HARDWARE INSTALLATION
This section describes how to set the connectors of the TA7102.
Warning:
Do not connect the TA7102 directly to Telecommunication Systems.
Caution:
The TA7102 must be installed on a circuit equipped with a breaker so that you can easily power
the unit off if required.
See
Appendix B - Cabling Considerations
, for more details on the cables the TA7102 uses.
Connecting Cables
The following describes how to connect the various cables to the TA7102.
Figure 5:
TA7102 Hardware Installation
2 4
3 5
1. Before you begin, be sure that the TA7102 is powered off.
2. Connect analog telephones or fax machines into the Pohne-Fax 1 and Phone-Fax 2 connectors. Use
a standard telecommunication cord with a minimum of 26 AWG wire size.
Note:
The TA7102 telephone line interface has been designed to interface with a conventional telephone
or fax machine. Connections to FXS ports of third party devices such as a PBX / Key System could
damage the TA7102.
3. Connect a 10/100 BaseT Ethernet RJ-45 cable into the
WAN
connector of the TA7102; connect the
other end to a compatible Ethernet interface that supplies TCP/IP network access (e.g., router,
switch, hub or computer). Use a standard telecommunication cord with a minimum of 26 AWG wire
size. You can either use a crossover or straight Ethernet cable because it performs automatic MDI /
MDIX detection. See
“RJ-45 Cable” for more details.
4. Connect a 10/100 BaseT Ethernet RJ-45 cable into the
LAN
connector of the TA7102 and connect
the other end to the network card of a computer. Use a standard telecommunication cord with a
minimum of 26 AWG wire size. You can either use a crossover or straight Ethernet cable because it
performs automatic MDI / MDIX detection. See
RJ-45 Cable
for more details.
5. Connect the power cord to the TA7102. Do not yet connect the other end of the power cord to an
electrical outlet. You are now ready to start the TA7102.