TA7102 Hardware Installation
24
153/1531-ANF 901 14 B 2017-03-08
Note:
On Windows, a scope ID needs to be added to the link local address
([fe80::290:f8ff:fe12:3456
%11
]).
You can find this number by executing the ‘ipconfig’ command in a
command prompt. Note the number at
the end of the IPv6 default Gateway for the interface used to contact the unit.
On Linux, the scope identifier may be the link name or the interface number. The interface number can be
determined through the Linux command line.
Vocal Unit Information
When entering special characters on your telephone pad, the TA7102 talks back to you with relevant
information.
To access vocal unit
information:
1. Take one of the telephones connected to the TA7102.
2. Dial one of the digits sequence on the keypad.
Table 4:
Vocal Unit Information
Digits to Dial
Information Vocally Sent by the TA7102
*#*0
Current IP address of the TA7102 (static or DHCP).
*#*1
MAC address of the TA7102.
Verifying the Installation
There are a few ways to verify that the TA7102 is properly connected to the IP network and is working:
By contacting it with a SNMP browser
By contacting it via the CLI
By contacting it via a web browser
By pinging it
These procedures assume that you know the IP address of the TA7102 you want to verify. If the
TA7102 does not respond, do the following:
Verify that the LAN and WAN cables are securely connected to the TA7102 and to the network
connectors.
Be sure that you did not connect crossover network cables.
Verify the state of the IP network to ensure it is not down (the ETH LED should be ON or blinking).
