TA7102 Hardware Installation
31
153/1531-ANF 901 14 B 2017-03-08
To trigger the Factory Reset:
1. Power the TA7102 off.
2. Insert a small, unbent paper clip into the
Reset / Default
hole located at the rear of the TA7102.
While pressing the
Reset / Default
button, restart the unit. Do not depress before the LEDs stop
blinking and are steadily ON.
3. Release the paper clip. The TA7102 restarts. This procedure resets all variables in the MIB modules
to their default value. When the TA7102 has finished its provisioning sequence, it is ready to be used
with a DHCP-provided IP address and MIB parameters. This procedure can also be performed at run-
time.
Note:
The Factory reset alters any persistent configuration data of the TA7102.
4.4
MANAGEMENT CHOICES
Congratulations for properly installing the TA7102. You can now configure the software parameters of the
unit.
The TA7102 offers various management options. All these options are described in the
Dgw v2.0
Software Configuration Guide
.
Table 8:
Management Options
Management Choice
Features
Web GUI
The TA7102 web interface allows you to configure the following
information:
•
Network attributes
•
SIP parameters
•
VoIP settings
•
Management settings such as configuration scripts, restore /
backup, etc.
SNMPv1/2/3
The TA7102 SNMP feature allows you to configure all the MIB services.
Command Line
Interface (CLI)
The TA7102 CLI feature allows you to configure all the MIB services.
Unit Manager
Network
The UMN offers the following:
•
Auto-discovery
•
Group provisioning
•
SNMP access and remote management.