2800LX ,UX / 3600UX Brushcutter
21
Original Instructions Version July 12
•
While holding the unit, pull out the starter rope firmly until engine fires (indicated by a ‘cough’
from the engine).
•
Move the choke lever to the open position.
•
Pull the starter rope until the engine starts, then squeeze the throttle briefly to release the fast idle
control and return the engine to idle. (2600LX only)
•
Allow the engine to warm up before use. When cutting, always use the brush cutter on full
throttle.
Hot Engine Starting
•
Set the ignition switch to the RUN ( I ) position.
•
Hold the safety lever down, and squeeze the throttle control lever. Push down and hold the fast
idle control, then release the throttle control and release your hand.
•
Pull the starter rope until the engine starts, then squeeze the throttle briefly to release the fast idle
control and return the engine to idle.
•
If the engine does not start after 5 pulls, use the cold start procedure.
Overchoking
Should the engine become flooded due to overchoking, turn the ignition switch off, unscrew the spark plug,
wipe it dry or replace, pull the recoil starter several times without the spark plug in place and with choke in
the open position. This will help clean and ventilate the combustion chamber.
Stopping the Engine
Set the engine to idling by releasing the throttle lever.
Set the ignition switch to the off position ‘’O’’ (STOP).
If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use the
machine until the ignition switch is repaired.
NOTE