415CSX PREMIUM Chainsaw
21
Original Instructions Version July 18
415CSX_030718
Maintenance After Each Use
Oiling port
Dismount the guide bar and check the oiling port (1) for
clogging.
Guide bar
When the guide bar is dismounted, remove sawdust from
the bar groove and the oiling port.
Grease the nose sprocket with a sprocket grease gun
(Oregon part number 21939)
1.
Guide bar groove
2.
Oil hole
3.
Drive sprocket
4.
Grease point
Reverse guide bar occasionally to prevent partial wear. The bar rail should always be square. Check
for wear of the bar rail. Apply a ruler to the bar and the outside of the cutter. If a gap is observed
between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be replaced.
1.
Ruler
2.
Gap
3.
No gap
4.
Chain tilts
Other Checks
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and
guide bar mounting. If any defects are found, make sure to have them repaired before operating
the saw again. Check for cracks and for excessive wear interfering with the chain drive. If the wear
is considerable, replace it with a new one. Never fit a new chain on a worn sprocket, or a worn
chain on a new sprocket.
