760BPX Premium
Original Instructions Version June 16
760BPX_2805161
17
7. Pull the starter handle (16) again until the engine starts (fig. 12)
8. When the engine has started, allow the engine run to at idle for
10 seconds.
9. Rev the engine a little using the throttle trigger (9) to warm it up
before using the machine.
IMPORTANT If the starter rope is pulled repeatedly with the choke on, it may flood the
engine and make starting difficult.
If you happen to flood the engine, follow the below procedure:
Set the ignition switch to the STOP position O. Turn the choke to the «OPEN» position. Remove the
spark plug and dry it. Pull the recoil starter handle slowly several times to drain the fuel from the
combustion chamber. Wait until the fuel evaporates and refit the spark plug.
3.1.2 Adjusting the Harness
The harness must always be worn when
working with the machine. Failure to do so
means you will be unable to manoeuvre
safely and this can result in injury to yourself
or others.
•
Make sure that the waist belt is closed
and correctly adjusted.
•
There is a risk that an unclosed belt can
get stuck or sucked into the fan of the
machine.
3.1.3 Hot Starting
To hot start the engine immediately after it has stopped, follow steps 1 - 3 - 4 - 6 - 7 of the above
procedure, making sure the choke knob is set on the «RUN» position.
