MIO-6706 Quick Start Guide
4
Chapter 2
The Development Kit
2.1 The Dimensions
The fixture board PCB size is 55 x 40 mm. The IO board PCB size is 75 x 70 mm.
2.2 Connecting the Boards and Powering Up
1
Connect the fixture board and the IO board. Connect the included antenna to the IO board’s
antenna connector.
2
Connect the Micro-USB port of the Development Kit to the included Micro-USB adapter.
3
Connect the adapter to a proper power source to power up the Development Kit.
2.3 Connecting to a Computer and Starting Up
Follow the steps below to connect the Development Kit to a computer and start it up.
1
Power up the Development Kit by following the steps in
Section 2.2 on page 4
.
2
Connect the 4-pin UART port of the Development Kit to your computer’s USB port with an RS232
cable. Make sure the computer is powered on.
3
You can access the Development Kit via various command tools in Linux and Windows
environments. The following example uses Windows 10 and Tera Term.
4
In Windows, open
Device Manager
and check for a new COM port.
COM8
is used in this example.
