14
NP180/160 Series Setup Manual
3.
LED unit mounting
Base stand
1.
Prepare a suitable base stand that fit into the
installation site.
2.
By means of a level, adjust the surface on the
base stand to be flat, which supports the LED
units.
3.
Insert adjustment screws on the base stand.
The screws are supplied with the LED units.
The screw head is decentered. Align the longer
direction of the heads with the horizontal
direction of the base stand.
LED units
Mounting
During the work, be careful not to make an
impact or apply pressure on the LED surface and
the edges.
It is recommended to properly put spacers (p.6)
on the LED edges for protection when mounting
the LED units.
Due to the center of gravity, the upper part of the
LED units tends to lean to front. Hold the upper
handle as well as the lower dent to support.
1.
Prior to the mounting, connect the necessary
cables to the LED units that will be located in
the bottom row.
With the rear maintenance models, the
connection can be done after the LED unit
mounting.
12NP180
15NP180
Base stand
Adjustment screw
Longer direction
Handle
Dent
Even column
Odd column
Control unit
Control unit
Adapter
Even column
Odd column
Control unit
Control unit
Adapter
Summary of Contents for 12NP180 Series
Page 50: ......