10
(b) Connecting a cable to the spring clamp terminal block
The following explains connecting method of a cable to a spring clamp
terminal block.
For the stripping method of the cable end, refer to Section 5.3. in this
manual.
Use a recommended screwdriver or equivalent for connecting or
disconnecting cables.
For details of the driver, refer to Appendix.5 in the Q corresponding
MELSECNET/H Network System Reference Manual (PLC to PLC
network).
1) Connecting the cable
Fully insert the cable into the correct opening with the open/close
button pressed by a slotted screwdriver.
When using a bar terminal, the cable can be inserted without
pressing the button.
Insertion hole
Open/close button
2) Disconnecting the cable
Keep pressing the open/close button by a slotted screwdriver until
the cable is completely pulled out.
5.2 Twisted Bus System (When using Version 1.10 compatible CC-Link
dedicated cable)
5.2.1 Specifications of Version 1.10 compatible CC-Link dedicated cable
The following table shows the specifications of the Version 1.10 compatible
CC-Link dedicated cable used for the twisted bus system.
The following Version 1.10 compatible CC-Link dedicated cable can be used.
Product name
Model
Manufacturer
FANC-110SBH
Mitsubishi Electric System & Service Co.,
Ltd.
Version 1.10 compatible
CC-Link dedicated cable
FA-CBL200PSBH
Mitsubishi Electric Engineering Co., Ltd.
