13-255
13-255
13.7.2. CC-Link IE Field Parameters
Set the information of CC-Link in the robot controller.
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Field network parameter] ->
[CC-Link IE Field].
After you change the parameter value, you can rewrite the parameter in the robot controller by clicking the [Write]
button.
Figure 13-69
CC-Link IE Field parameter
You can reference explanations of displayed parameters by pressing the [Explain] button.
This function can only be used with a CRnD-800 series robot controller.
Caution
Summary of Contents for 3F-14C-WINE
