CIGARETTE LIGHTER Cigarette Lighter
CIGARETTE LIGHTER
REMOVAL AND INSTALLATION
Removal steps
1. Ashtray
2. Heater control knob
3. Heater panel
4. Plug
5. Fixing ring
6. Socket case
7. Plate
8. Socket
9. Protector
7
INSPECTION
l
Take out the plug, and check for a worn edge on the
element spot connection, and for shreds of tobacco or
other material on the element.
l
Using an ohmmeter, check the continuity of the element.
CAUTIONS FOR USE OF THE CIGARETTE LIGHTER
SOCKET AS AUXILIARY POWER SOURCE
1. When using a “plug-in”
of accessory, do not use
anything with a load of more than
2. It is recommended that only the lighter be inserted in
the receptacle.
Use of “plug-in” type
may damage the
receptacle and result in poor retention of the lighter.
NOTE
The specified load should be strictly observed, because
overloaded cord burns the ignition switch and harness.
TSB Revision
1