METERS AND GAUGES Meters and Gauges
I
SERVICE POINTS OF REMOVAL
3. REMOVAL OF THE COMBINATION METER
(1) Remove the mounting screws; then remove the
combination meter by turning the upper part of it
toward the front.
(2) For models equipped with the automatic position
indicator, disconnect the harness connector before
removing the combination meter.
4. REMOVAL OF ADAPTER
(1) Disconnect the speedometer cable at the transmission
end of the cable.
(2) Pull the speedometer cable slightly toward the vehicle
interior, release the lock by turning the adapter to the
left or right, and then remove the adapter.
INSPECTION
REED SWITCH INSPECTION
Use circuit tester to check circuit repeats off/on between
terminals when speedometer shaft turned several times.
FUEL GAUGE CIRCUIT INSPECTION
Measure resistance between terminals with circuit tester.
Standard value:
A - B
Approx. 203
A - C
Approx. 102
Approx. 102
ENGINE COOLANT TEMPERATURE GAUGE CIRCUIT IN-
SPECTION
Measure resistance between terminals with circuit tester.
Standard value:
Vehicles built up to Dec. 1988
A - B
Approx. 130
A - C
Approx. 53
B-C
Approx. 162
Vehicles built from Jan. 1989
A - B
Approx. 146
A - C
Approx. 60
B - C
Approx. 206
Revision